AB Night Vision RNVG HOUSING (No Optics. No Tubes. Housing Only)

The RNVG is designed as the most rugged night vision goggle available.  While most NVG’s are built with molded polymer housings, the RNVG features a 7075 aluminum chassis for unsurpassed rigidity and structural strength.  All articulation points have been beefed up to increase impact resistance, giving users one tough goggle.  Designed and machined at AB NightVision, and finished / assembled at TNVC, the Ruggedized Night Vision Goggle is ready to face the toughest customers and harshest environments!

Traditionally, the weakest point in a night vision goggle is the joint between the optic pods and the bridge.  This point accounts for the majority of catastrophic breakage when a NVG is dropped or hit.  Part of this reason is that these joints are either polymer on polymer or metal on polymer interfaces.  While there are some seriously impact resistant polymers out there, it’s hard to beat aluminum for strength to weight ratios.  Both the optic pods and bridge in the RNVG are machined from solid billet 7075 (a material that is 36% stronger than most common steel), to give end users the strongest NVG on the market (not to mention a little piece of mind).  Careful design and advanced machining keep the weight down to 20 oz. with a battery installed.

The RNVG eliminates exposed wires – something commonly found in ANVIS-style night vision goggles. As the optic pods traverse during interpupilary adjustment, they ride across an electrical contact strip.  This provides much increased weather/element resistance and reduces a traditional failure point.  IP adjustment is accomplished with by turning dual knobs on either side of the bridge; the same as any traditional ANVIS goggle.

The RNVG utilizes a single CR123 battery, and comes with an auxiliary power connector for use with ANVIS-style auxiliary battery packs such as the USGI Low Profile Battery Pack or AB Night Vision Ground Optimized Battery Pack.

Controls are simple.  If you are familiar with a PVS-14, you will be right at home with the RNVG.  A standard PVS-14 power knob is located on the front of the bridge.  It features on/off controls, and active IR illuminator mode.  Just like a 14, simply pull the knob out and twist it all the way to turn on the built-in infrared illuminator.  The RNVG features a dovetail mount interface.

RNVG housings are anodized black, but Cerekote finishes are available.  The tan goggles shown in the images are Coyote Cerekote.

Export of Night Vision Equipment or related accessories (such as manuals) is strictly regulated by the US Department of State in accordance with the guidelines of the International Traffic in Arms Regulations (ITAR). It is a major crime to ship or carry US manufactured night vision devices outside the borders of the United States, punishable by fines and prison sentences. Ignorance of these regulations will not hold up in court. By purchasing night vision equipment from TNVC, you attest that you will not attempt to export or carry this night vision equipment outside the borders of the United States. Also, it illegal to allow a non-US Citizen to look through US Gen3 Night Vision Devices, even on US soil. Again, this is a crime punishable by fines and prison sentences.